ADC-V522IR - Recommended Installation Method

Router Connection

Connect the camera to the network router by one of two methods

Ethernet Cable

Plug camera into network router by Ethernet cable and wait 2 minutes for camera to boot

 Or WPS WiFi Protected Setup Mode (Method 2)

1. Plug in camera power adapter and wait 2 minutes, camera LED should turn red

2. Insert pin or paperclip into hole and hold button for 5 seconds, blue LED flashes

  


3. Press and release WPS button on the router or enable WPS in router programming

Screenshot_at_Dec_02_16-59-54.png

 4. Wait 2 minutes, if successful camera LED turns green, if failure LED turns red

Alarm.com Setup

1. From the customer website select Video

01_Home_Page.png

2. Select Settings

02_Video_Page.png

3. Select Add Video Device

03_Video_Settings.png

4. If the camera is found press Name then enter the camera name then press INSTALL

04_Add_V521_Camera_-_Camera_Found.png

5. Alarm.com sends configuration data to the camera, this may take several minutes

05_Add_V521_Camera_-_Configuring.png

6. When finished press Live View to view camera image

06_Add_V521_Camera_-_Installation_Complete.png

7. If connected by Ethernet cable and needing to configure WiFi press SETTINGS

07_Add_Camera_-_Live_View_Program_Wireless.png

8. Select camera from dropdown box

Select_Camera.png

9. Scroll down and select Wireless Network

08_Add_Camera_-_Select_Wireless_Settings.png

10. Press SCAN

09_Add_Camera_-_Choose_Method.png

11. Select wireless network

10_Add_Camera_-_Found_Networks.png

12. Enter WiFi encryption then press NEXT

10_Add_Camera_-_Enter_Encryption.png

13. Unplug Ethernet cable then cycle power to the camera and wait 2 minutes to reboot

11_Add_V521_Camera_-_Wireless_Complete.png

Was this article helpful?
0 out of 2 found this helpful

Comments

0 comments

Please sign in to leave a comment.