ADC-V522IR Indoor Camera - WiFi and Alarm.com Setup

Router Connection

Connect the camera to the network router by one of two methods

Ethernet Cable

Plug Ethernet cable into camera and port on customer's router then wait 2 minutes

WIFI WPS protected setup mode

1. Insert paperclip into hole and hold button for 5 seconds, blue LED flashes

ADC-V522IR_Camera_WPS_Enrollment.jpg 
2. Press and release WPS button on router or enable WPS mode in router programming

Screenshot_at_Dec_02_16-59-54.png

3. Wait 2 minutes, if successful camera LED turns green, if failure LED turns red

Alarm.com Setup

1. From the customer website press Video

01_Home_Page.png

2. Press Settings

02_Video_Page.png

3. Press Add Video Device

03_Video_Settings.png

4. If the camera is found press Name then enter the camera name then press INSTALL

04_Add_V521_Camera_-_Camera_Found.png

5. Alarm.com sends configuration data to the camera, this may take several minutes

05_Add_V521_Camera_-_Configuring.png

6. When finished press Live View to view camera image

06_Add_V521_Camera_-_Installation_Complete.png

7. If connected by Ethernet cable and needing to configure WiFi press SETTINGS

07_Add_Camera_-_Live_View_Program_Wireless.png

8. Select camera from drop-down box

Select_Camera.png

9. Scroll down and select Wireless Network

08_Add_Camera_-_Select_Wireless_Settings.png

10. Press SCAN

09_Add_Camera_-_Choose_Method.png

11. Select wireless network

Alarm.com_Setup_10.png

12. Enter WiFi encryption then press NEXT

Alarm.com_Setup_11.png

13. Unplug Ethernet cable then cycle power to the camera and wait 2 minutes to reboot

11_Add_V521_Camera_-_Wireless_Complete.png

Was this article helpful?
1 out of 2 found this helpful

Comments

2 comments

Please sign in to leave a comment.