Qolsys IQ Panel 2 - IQ Window Sensor Installation Guide

1. Identify the location for the sensor from the label on the box.

1.jpg

 

2. Clean the location on the window where the sensor will be installed

3.jpg

3. Remove the tape backing from the sensor and magnet. Place the sensor on the frame and the magnet on the window

Note: The sensor and magnet must be no more then a pencil width apart.

4.jpg

IMPORTANT: Make sure the arrow on the magnet is on the side closest to the sensor.

5.jpg

IMPORTANT: Make sure the arrow on the sensor is on the side closest to the magnet, and that the arrows on each device are aligned.

align.jpg

Was this article helpful?
0 out of 1 found this helpful

Comments

0 comments

Please sign in to leave a comment.