How to properly reset an Alarm.com Camera

Warning This erases all camera programming!

Camera WiFi must be reprogrammed and re-added to Alarm.com

If the light on your camera blinks green, but doesn't turn solid or the camra fails to configure. Follo these steps to reset your camera and reconnect to your router.

  • Press the reset button and hold it.
  • The light should flash red, green, red, green.
  • Continue holding it until the light turns solid red and then turns off (about 15 seconds).
  • After the light turns off you can release the reset button and unplug the power for 10 seconds to complete the reset.

Then follow these directions to re-add the camera again. If you are connecting via an ethernet cable, make sure to connect it before you power the camera back up.

Presentation1.jpg
Presentation1.jpg
Presentation2.jpg
Presentation1.jpg
For the ADC-V72W, you'll need to hold the "WPS" button for 10 seconds to reset it. You'll know it's complete when the camera starts flashing a white LED light.
Picture1.png
Was this article helpful?
1 out of 1 found this helpful

Comments

0 comments

Please sign in to leave a comment.