Simon XT - Programming Garage Door Sensor

Simon_XT_v1.3_Scroll_Buttons.jpg

1. Press UP or DOWN ARROW button until SYSTEM PROGRAMMING then press OK

Simon_XT_Disarmed.png Simon_XT_Then.jpg Simon_XT_System_Programming.png  

2. Enter the Installer Code 4321 (Call Brinks Home Security if this code is different)

Simon_XT_Enter_Code.png Simon_XT_Then.jpg Simon_XT_Access_Codes_Main.png

3. Press UP or DOWN ARROW button until SENSORS then press OK

Simon_XT_Sensor_Program_01.png Simon_XT_Then.jpg  Simon_XT_Sensor_Program_02.png

4. Press OK again to place the panel in learn mode

Simon_XT_Sensor_Program_02.png Simon_XT_Then.jpg  Simon_XT_Sensor_Program_03.png

5. Remove then replace the sensor cover to learn

Tilt_Sensor.jpg

6. The Simon XT beeps and Grp flashes, press OK

Simon_XT_Sensor_Program_06a_Glassbreak.png Simon_XT_Then.jpg Simon_XT_Sensor_Program_06aa_Glassbreak.png

7. Sensor name flashes, press UP or DOWN ARROW buttons to scroll names then press OK to select

Simon_XT_Sensor_Program_06a_Glassbreak.png Simon_XT_Then.jpg Sensor_Program_06_Garage_Door.png

8. When finished press OK

Sensor_Program_06_Garage_Door.png Simon_XT_Then.jpg Simon_XT_Sensor_Program_06f_Glassbreak_Trip_Sensor_11.png

9. Press STATUS button twice to exit sensor programming

Simon_XT_Sensor_Program_02.png Simon_XT_Then.jpg Simon_XT_Sensor_Program_01.png

10. Press STATUS button again to exit installer programming

Simon_XT_System_Programming.png Simon_XT_Then.jpg Simon_XT_Disarmed.png

 

Was this article helpful?
1 out of 1 found this helpful

Comments

0 comments

Please sign in to leave a comment.