Simon XT - Programming A Motion Detector

To program your motion detector, follow these steps:

Picture1.png

At this point, you’ll need to tamper your sensor. To do this, press the tab at the bottom of the motion detector and then remove the casing. 

graphic_2.png

Once you hear a beep on the system, it will display the blue screen shown below. "Sn" stands for the sensor number. The "Grp" number is used to change the behavior of the device. Then there is the default name "Front Door" which can be changed by scrolling up or down using the arrows on your keypad.

At the moment, the "Grp 10" will be flashing, indicating you are in edit mode. For the device, enter "17" and then press "OK".

Now, the "Front Door" will be flashing. Scroll up or down till you have found the proper name and then select "OK" twice.

graphic_2.png

When the screen says "Trip Sensor 2", you can either continue adding new sensors or you can press the "Status" continuously till you reach the disarm screen.

You’re done! Reconnect the casing to the body of the device. 

Was this article helpful?
0 out of 0 found this helpful

Comments

0 comments

Please sign in to leave a comment.