Simon XT - Programming A Temperature Sensor

Picture1.png

For the IQ Temp, there are 2 sensors built into the device, a freeze sensor and a heat sensor. We will need to enroll each sensor separately into the panel. Start by opening the casing of the device by pushing-in the tab with a flat blade screwdriver.

gra_11.png 

Once you hear a beep on the system, it will display the blue screen shown below. "Sn" stands for the sensor number. The "Grp" number is used to change the behavior of the device. Then there is the default name "Front Door" which can be changed by scrolling up or down using the arrows on your keypad.

At the moment, the "Grp 10" will be flashing, indicating you are in edit mode. For the freeze, enter "29" and press "OK".

Now, the "Front Door" will be flashing. Scroll up or down till you have found the proper name and then select "OK" twice.

graphic_2.png

When the screen says "Trip Sensor 2", you'll need to enroll the Heat sensor. With the casing removed, push the batteries out from the metal contacts. Press down on the tamper switch while re-inserting the batteries. 

gra_22.png

Once you hear a beep on the system, it will display the blue screen shown below. "Sn" stands for the sensor number. The "Grp" number is used to change the behavior of the device. Then there is the default name "Front Door" which can be changed by scrolling up or down on the arrows on your keypad. 

At the moment, the "Grp 10" will be flashing, indicating you are in edit mode. For the temp, enter "26" and press "OK".

Now, the "Front Door" will be flashing. Scroll up or down till you have found the proper name and then select "OK" twice.

graphic_2.png

When the screen says "Trip Sensor 2", you can either continue adding new sensors or you can press the "Status" continuously till you reach the disarm screen.

Was this article helpful?
0 out of 0 found this helpful

Comments

0 comments

Please sign in to leave a comment.