Simon XT - System Programming Not Appearing On Display

The reason you do not have the option to get into System Programming is because the system is armed. Sometimes you can accidentally arm the system when you power it up with the keypad face down on the table. You need to disarm the system before you can access the programming menus. To disarm you need to:
  1. Press Disarm
  2. Enter your master passcode 
  3. You may now scroll down until you see system programming
  4. Enter your programming code (factory default is 4321 notice this is the opposite of the factory default arming/disarming code) then OK. Note, this programming code cannot be used when your system is armed (hence the reason for this article).
  5. The system will display access codes. You are now in programming.
Was this article helpful?
2 out of 2 found this helpful

Comments

0 comments

Please sign in to leave a comment.