Simon XT - Programming Recessed Door/Window Sensors

Enrolling A Designline Recessed Door/Window Sensor Into the Simon XT:

Before entering into programming make sure your system is disarmed to add the device.

add_a_sensor__part_1_.JPG

 

Take the larger contact and unscrew the top section, counterclockwise. This will tamper the device and send a signal to the system to enroll.

2.JPG

 

If Successful, the Simon XT will beep and the LCD Info Screen will display “Sn # Grp 10 Front Door

Then, configure the sensor group below:

Group Type

Group #

Keychain

1

Touchscreen

1

Panic

1

Exit or Entry Door

10

Window

13

Non Exit/Entry Door

13

Motion

17

Smoke/Fire

26

Freeze

29

Water

38

Carbon Monoxide

34

add_a_sensor__part_2_.JPG

Once you have finished programming the device, press the "Status" button until you reach "Disarmed". You are done!

Was this article helpful?
0 out of 0 found this helpful

Comments

0 comments

Please sign in to leave a comment.