Simon XT - Mounting Your System On The Wall

1. Start by opening the system by pressing down on the two tabs at the top of the system. (You may need to remove a screw first)

1.png

2. On the inside back cover of the Simon XT, push the tabs out (highlighted in red).

2.png

3. (A) Unscrew and disconnect the power wires from the Simon XT. (B) Route the wires outside of the desk mount.

Picture3.png

4. Re-route the "Power Wires" and connect them back to the Simon XT.

Picture4.png

5. On the back of your system, you can hang it from the following areas...

Picture5.png

6. You'll need to put a screw or nail in the wall and then mount the system on the wall...

Picture66.png

Was this article helpful?
3 out of 3 found this helpful

Comments

0 comments

Please sign in to leave a comment.