Honeywell Lynx Touch - Programming Sensors

The following information will show you how to add a sensor(zone) to your Lynx Touch:

1. Press MORE then TOOLS then enter the Installer Code 4112

Home Page1.jpg Home Page More2.jpgHome Page More2.jpg Enter Code.JPG

2. Press PROGRAM then ZONES then ADD NEW

Tool - program1.jpg System programming1.jpg 

ZOne edit1.jpg

3. Press SERIAL NUMBER then enter the serial number on the sensor sticker or trip sensor twice to learn

Zne program1.jpg Serial number.JPG

 

4. Press LOOP NUMBER to toggle loop 1, 2 or 3, see chart below

 

5. Press ZONE DESCRIPTION then enter sensor name or scroll names with arrow then press DONE 

 

6. Press DEVICE TYPE then enter type of sensor

 

7. Press RESPONSE TYPE then select if delay, instant, 24 hour etc

 

8. Set ALARM REPORT to YES, CHIME to YES, SUPERVISION to SUPERVISED then press SAVE to exit

 

 

9. Press BACK ARROW then press YES to exit programming

  

Was this article helpful?
0 out of 0 found this helpful

Comments

0 comments

Please sign in to leave a comment.