DSC - View And Silence Troubles

Yellow Triangle Trouble LED turns ON, keypad beeps every 10 seconds, press * then 2 to view then # to silence and exit

 

LED Keypads

DSC_Trouble_Lights.jpg

Press * 2, yellow triangle trouble light flashes and Zone lights turns ON indicating trouble, press # to exit

Zone Light 1 = Service Required, press 1 to show exact trouble then press # to exit

  • Light 1 = Low Panel Battery
  • Light 2 = Siren Trouble
  • Light 3 = General System Trouble (External module trouble)
  • Light 4 = General System Tamper (External module tamper)
  • Light 5 = General System Supervisory (Lost communication with module)
  • Light 6 = RF Jamming (Wireless receiver is being jammed by outside source)
  • Light 7 = 5204 Power Supply Module Low Battery
  • Light 8 = 5204 Power Supply Module AC Failure

Zone Light 2 = AC Failure

Zone Light 3 = Telephone Line Trouble (Phone line trouble)

Zone Light 4 = Failure to Communicate (Over phone line)

Zone Light 5 = Zone Fault / Trouble, press 5 to show Zone (Usually dead battery or bad sensor)

Zone Light 6 = Zone Tamper, press 6 to show Zone (Usually sensor cover loose or off)

Zone Light 7 = Zone Low Battery, press 7 to show which Zone

  • Press 7 again for Keypad low batteries
  • Press 7 again for Keyfob low batteries

Zone Light 8 = Loss of System Clock (See Set Time & Date)

Alphanumeric LCD Keypads

Press * then 2 to view, Alphanumeric keypads displays trouble test, press # to exit

    

 

 

 

 

Was this article helpful?
0 out of 0 found this helpful

Comments

2 comments
  • My DSC 832 has the trouble light blinking about every 20 seconds. When I do a *2 the displays "no system troubles" The panel is also chirping every couple minutes. Is there a reason that this is happening?

  • Hi James, 

    Do you have any wireless devices or expansion devices connected to your system? Do you have a LCD or LED keypad?

Please sign in to leave a comment.