Simon XTi - Panel Wall Mounting

1. Insert a coin into the bottom right slot to pry the trim ring off front cover

simon-xti-remove-trim-ring.jpg

2. Remove the trip ring from the front of the Simon XTi

simon-xti-trim-ring.JPG

3. Lift up on the two tabs at the top of the panel to open the cover

simon-xti-open-tabs.jpg

4. Swing the cover from the back plate

simon-xti-open-panel.JPG

5. With panel is open remove 2 tabs circled in red in picture below

Push or pry out bottom tab circled in blue in picture below

simon-xti-remove-desk-base-tabs.jpg

6. Unplug transformer and disconnect two white power wires from screw terminals

7. Pull wire out of the desk mount through back plate, and reattach the two wires

Picture1.png

7. Insert screws into screw holes by red arrows and place system on wall

marking.png

Picture2.png

Was this article helpful?
1 out of 1 found this helpful

Comments

2 comments
  • Almost.  Almost got 100%.  nice pix.  well laid out.  BUT I have a bleeping black [cell antenna ?]cable that will NOT go through hole in the desktop base.  do i unplug it from the cell board?  if i do will it plug back in ? how critical is this antenna anyway?  can i use the unit without it ??  sure wish I knew.

    1
    Comment actions Permalink
  • I like the idea of being able to mount the system to the wall, the only downside is the wires hanging down from the system. Its just really an eye sore and makes system look cheap

    0
    Comment actions Permalink

Please sign in to leave a comment.