Simon XTi - Programming An Image Sensor


1. Press the GEAR icon then scroll down until you reach System Programming


2. Press ENTER by System Programming then enter the Installer Code 4321


3. Press SENSORS then press LEARN SENSOR


4. Pull motion up from backplate then insert batteries to learn


5. Wait 1 minute, the Simon XTi beeps, press EDIT by sensor group then enter 17 then press SAVE


6. Press EDIT by "Sensor Name" then press EDIT by word then scroll words then press SAVE to exit


7. Press CLOSE twice to exit sensor programming


8. Press CLOSE twice to exit Simon XTi programming


Was this article helpful?
0 out of 0 found this helpful


1 comment

Please sign in to leave a comment.