When a Duress Code is used to disarm the system, it sends a silent duress alarm to the monitoring station

1. Click on the GEAR icon at the bottom right then press DOWN ARROW several times

Enter_Programming_01_Main.jpg Enter_Programming_02_Settings.jpg

2. Press ENTER by Programming then enter your Master Code then press OK

Enter_Programming_03_Programming_Enter.jpg Enter_Programming_04_Enter_Code.jpg

3. Press ACCESS CODES then press DOWN ARROW

Access_Codes_00.jpg Duress_Code_01.jpg

4.  Press Empty Box by Duress Code then enter the new Duress Code then press SAVE to exit

Duress_Code_02.jpg Duress_Code_03.jpg

5. Press CLOSE twice to exit

Duress_Code_04.jpg Exit_Programming_01_Exit.jpg

Was this article helpful?
3 out of 3 found this helpful

Comments

0 comments

Please sign in to leave a comment.