1. Press the GEAR icon at the bottom right-hand corner then press DOWN ARROW several times

Interface001.jpg Enter_Programming_02_Settings.jpg

3. Press ENTER by Programming then enter the Installer Code 4321 then press OK

Enter_Programming_03_Programming_Enter.jpg Enter_Programming_04_Enter_Code.jpg

 4. Press SENSORS then press EDIT SENSOR

sensors.png edit_sensor_2.png

5. Press EDIT by sensor then press SENSOR NAME

Programming_-_Edit_Sensors_02.png Programming_-_Edit_Sensors_03.png

6. Press EDIT by name word then select word from list then press SAVE to exit

Programming_-_Sensors_06.png Programming_-_Sensors_07.png

7. Press CLOSE several times to exit 

processing_re.png Programming_-_Sensors_08.png 

Was this article helpful?
1 out of 2 found this helpful

Comments

0 comments

Please sign in to leave a comment.