1. Press bottom right GEAR icon then press DOWN ARROW several times

Enter_Programming_01_Main.jpg Enter_Programming_02_Settings.jpg 

2. Press ENTER button by System Tests then enter Master Code then press OK

Settings_02.jpg Settings_03_Enter_Code.jpg

3. Press SENSOR TEST then activate all sensors

Sensor_Test_01.jpg Tests_02_Sensor_Test.jpg

  • Door or Window Sensors - Open and close
  • Keyfobs - Press any button
  • Motion Detectors - Remove front of the motion sensor from the back plate
  • Smoke / Heat Detector - Hold Test button
  • Carbon Monoxide Detector - Hold Test button

4. Simon XTi beeps on activation and displays sensor signal strength, press CLOSE to exit

Sensor_Test_02.jpg Tests_03_Sensor_Test.jpg

5. When all sensors are tested press CLOSE twice to exit

Test_Exit_01.png Test_Exit_02.jpg

Was this article helpful?
0 out of 0 found this helpful

Comments

3 comments
  • Can you provide instructions for testing freeze and flood sensors too?

    0
    Comment actions Permalink
  • Thank you for contacting SafeMart. Please see the below steps to test the Freeze and Water Sensors

    Freeze Sensor / Water Sensor

    • Follow the steps above to put the panel in "Sensor Test" mode
    • Take the cover off the "Freeze Sensor / Water Sensor"
    • Press and hold the plastic tab marked "Press to Program" for at least one second.
    • You will then hear the Simon XTi go through a series of beeps.
    • You can then check how many packets were sent to the panel from the "Freeze Sensor / Water Sensor"
    0
    Comment actions Permalink
  • Can you test just one sensor?? 

    0
    Comment actions Permalink

Please sign in to leave a comment.