Qolsys IQ Panel - Programming A Motion Detector

Start by selecting “Settings”

1.png

Enter your “Installer Code”, in this case I’m going to use the default which is “1111”

2.png

Select “Installation"

3.png

Select “Security Sensors”

4.png

Select “Auto Learn Sensor”

5.png

At this point, you’ll need to tamper your device. To do this, take your motion detector and press the button at the top to remove the back mounting plate. 

     6.jpg ab.png

Once this is done, the IQ Panel will beep and ask if you want to add the device to your sensor list. Select “OK”

7.png

Here you will need to program the proper information for this device.

  • Sensor DL ID: Don't touch this option.
  • Sensor Type: Select “Motion Detector”
  • Sensor Name: Select an appropriate name or create a "Custom Description"
  • Chime Type: This allows you to apply a specific sound to your device when it’s used.
  • Sensor Group: This is used to change the behavior of the device. For this device, leave the Sensor Group alone.
  • Voice Prompts: This allows you turn on or off the vocal chime. 

Sensor_Tripped_-_Add_Sensor.jpg

When ready, select “Add New”

8.png

You’re done! Make sure to re-apply the back mounting plate on your device. 

Was this article helpful?
1 out of 1 found this helpful

Comments

1 comment
  • I ordered a new sensor and I want to be able to add it on my own to the panel, but I dont' see the Installer app under Settings. How do I get access to my panel to be able to add sensors on my own. One of the reasons I went with this unit was to be able to do certain administrative tasks on my own. Thank you.

Please sign in to leave a comment.