Qolsys IQ Panel - Programming An Alarm.com Image Sensor

Start by sliding the back mounting off the image sensor and removing one of the double AA batteries.

1.png  2.png

Make sure your system is disarmed during this process. Start by selecting “Settings”

1.png

Enter your “Installer Code”, in this case I’m going to use the default which is “1111”

2.png

Select “Installation"

3.png

Select “Security Sensors”

4.png

Select “Auto Learn Sensor”

5.png

At this point, you’ll need to re-insert the battery in your image sensor and slide the back mounting cover on the body of the device.

3.png   4.png

After 10-15 seconds, the IQ panel will show the following. Press “OK”, to continue with the enrollment.

Picture5.png

This screen will display the basic programming information for your Image Sensor, at this time, all you need to do is change the name…and then “Add New”

Picture6.png

You’re done with the enrollment of your Image Sensor. 

Was this article helpful?
1 out of 1 found this helpful

Comments

0 comments

Please sign in to leave a comment.