Router Connection
Connect the camera to the network router by one of two methods
Ethernet Cable
Plug camera into network router using an Ethernet cable and wait 2 minutes for camera to initialize
WPS WiFi Protected Setup Mode
1. Hold back button for 5 seconds, blue LED flashes
3. Press and release WPS button on router or enable WPS mode in router programming
4. Wait 2 minutes, if successful camera LED turns green, if failure LED turns red
Add Camera to Alarm.com
1. From the customer website press Video
2. Press Settings
3. Press Add Video Device
4. If the camera is found press Name then enter the camera name then press INSTALL
5. Alarm.com sends information to camera, this may take up to 5 minutes
6. When finished press Live View to view camera image
7. To configure WiFi press SETTINGS
8. Select camera from drop-down box
9. Scroll down and press Wireless Network
10. Press SCAN
11. Select wireless network
12. Enter WiFi encryption then press NEXT
13. Unplug Ethernet cable then cycle power to the camera and wait 2 minutes to reboot