ADC-V521IR Indoor Camera - WiFi and Alarm.com Installation

Router Connection

Connect the camera to the network router by one of two methods

Ethernet Cable

Plug camera into network router using an Ethernet cable and wait 2 minutes for camera to initialize

 Or

WPS WiFi Protected Setup Mode

1. Hold back button for 5 seconds, blue LED flashes

    

3. Press and release WPS button on router or enable WPS mode in router programming

Screenshot_at_Dec_02_16-59-54.png

 4. Wait 2 minutes, if successful camera LED turns green, if failure LED turns red

Screenshot_at_Dec_02_17-00-29.png

Add Camera to Alarm.com

1. From the customer website press Video

01_Home_Page.png

2. Press Settings

02_Video_Page.png

3. Press Add Video Device

03_Video_Settings.png

4. If the camera is found press Name then enter the camera name then press INSTALL

04_Add_V521_Camera_-_Camera_Found.png

5. Alarm.com sends information to camera, this may take up to 5 minutes

05_Add_V521_Camera_-_Configuring.png

6. When finished press Live View to view camera image

06_Add_V521_Camera_-_Installation_Complete.png

7. To configure WiFi press SETTINGS

07_Add_Camera_-_Live_View_Program_Wireless.png

8. Select camera from drop-down box

Select_Camera.png

9. Scroll down and press Wireless Network

08_Add_Camera_-_Select_Wireless_Settings.png

10. Press SCAN

09_Add_Camera_-_Choose_Method.png

11. Select wireless network

10_Add_Camera_-_Found_Networks.png

12. Enter WiFi encryption then press NEXT

10_Add_Camera_-_Enter_Encryption.png

13. Unplug Ethernet cable then cycle power to the camera and wait 2 minutes to reboot

11_Add_V521_Camera_-_Wireless_Complete.png

Was this article helpful?
0 out of 1 found this helpful

Comments

0 comments

Please sign in to leave a comment.