Qolsys IQ Panel 2 - Programming An IQ Glass Break Detector

Sensor Installation

1. Identify the location for the sensor from the label on the box

1.jpg

2. Remove the sensor from the box. Open the glass break detector by pressing the tab

2.jpg

3. Remove the plastic battery tabs and close the cover

3.jpg

4. Locate the glass break detector on the ceiling within 15 feet of the windows to be protected

4.jpg

5. Apply tape to back of the sensor and remove double-sided tape backing then apply pressure for 10 seconds

5.jpg

IQ Panel 2 Programming

1. Swipe down from the clock display at the top of the screen then press Settings

Enter_Program_01_Main.jpg Enter_Program_02_Dropdown.jpg

2. Press ADVANCED SETTINGS then enter the Installer Code 1111 or 2222

Enter_Program_03_Settings_Menu.jpg Enter_Program_04_Enter_Code.jpg

3. Press INSTALLATION then DEVICES

Installation_Screen.png 6.png

4. Press SECURITY SENSORS then AUTO LEARN SENSORS

7.png 8.png

5. Open the glass break detector cover to learn then press OK to confirm

 Auto_Learn_Confirm.png

2.jpg

6. Enter sensor information then press ADD NEW to save then HOME to exit

11.png Z-Wave_Add_09_Exit.jpg

  • Sensor DL ID: Don't touch this option
  • Sensor Type: Select “Glassbreak”
  • Sensor Name: Select an appropriate name or create a "Custom Description"
  • Chime Type: This allows you to apply a specific sound to your device
  • Sensor Group: Set this to "13" 
  • Voice Prompts: Leave this alone
Was this article helpful?
0 out of 0 found this helpful

Comments

0 comments

Please sign in to leave a comment.