2GIG GC3 - Remove Z-Wave Light Module

If the light module is still active follow these steps, if the light module has failed or is lost go here Remove Failed Smart Home Device

1. Press SYSTEM SETTINGS then enter the Installer Code 1561

GC3_Delete_Device_01_Ready_To_Arm.png GC3_Delete_Device_02_Enter_Code.png

2. Press SMART HOME SETTINGS then press REMOVE DEVICES

GC3_Delete_Device_03_Smarthome_Select.png GC3_Remove_Device_00_Smarthome_Main.png

3. 2GIG GC3 enters Z-Wave delete mode, press MATE or LEARN button on lamp module

GC3_Remove_Device_01_Remove_Device.png Z-Wave_Mate_Button.jpg

4. Press OK when finished then press GC3_Back_Arrow.png or the HOME button to exit

GC3_Delete_Device_09_Removed.png  GC3_Remove_Device_02_Device_Removed.pngGC3_Home_Button_2.jpg

Was this article helpful?
0 out of 0 found this helpful

Comments

0 comments

Please sign in to leave a comment.