2GIG GC3 - Programming WiFi Settings using WPS

1. Press SYSTEM SETTINGS then enter the Master Code

GC3_WiFi_Program_01_Ready_To_Arm.png GC3_WiFi_Program_02_Enter_Code.png

2. Press NETWORK SETTINGS then WIRELESS

GC3_WiFi_Program_03_System_Settings.png GC3_WiFi_Program_04_Network_Main.png

3. Press WPS then press the WPS Button on the router or enable WPS in the router settings

GC3_WiFi_WPS_01_Select_WPS.png Router_WPS_Button.jpg

4. Press CONNECT then wait up to 1 minute to connect to the WiFi network

GC3_WiFi_WPS_02_Connect.png GC3_WiFi_WPS_03_Working.png

5. If successful network settings appear, press GC3_Back_Arrow.png to exit, router should show "Connected", press GC3_Back_Arrow.png again or the HOME button to exit

GC3_WiFi_Program_08_Network_Stats.png GC3_WiFi_Program_09_Connected.pngGC3_Home_Button_2.jpg

Was this article helpful?
0 out of 0 found this helpful

Comments

0 comments

Please sign in to leave a comment.