Simon XT - Power Cycling The Panel

Brinks Home Security Tip: To restore communication, you can try a communication test before attempting to power cycle your panel.

1. Unplug the transformer then remove the screw on top of the panel then press two tabs to open cover

Simon_XT_Screw.jpg

2. Apply pressure to spread the battery clips, then remove the battery

Simon_XT_Battery_Clips.jpg

5. Disconnect the wires from the battery

Simon_XT_Battery.jpg

5. Wait 2 minutes, then reconnect the positive and negative leads from the panel to the battery (red wire to red terminal, and black wire to black terminal)

6. Reassemble the keypad

7. Plug in the transformer

Was this article helpful?
0 out of 0 found this helpful

Comments

0 comments

Please sign in to leave a comment.