2GIG GoControl - How to Cycle the Power

1. Disarm the system with your master or user code, then unplug the transformer


2. Locate and remove the screw on top of the keypad, and pry open slots with a flat head screwdriver


3. Gently pull the front cover down

4. Locate the third hand (a plastic piece that looks like an upside-down V), and place it over the notch in the center of the cover


5. Locate the green battery pack, and remove the clip that connects the battery to the circuit board (black and red battery wire)

6. Remove the battery, then wait 2 minutes and reconnect it

7. Reassemble the keypad, and plug in the transformer


Was this article helpful?
0 out of 1 found this helpful



Please sign in to leave a comment.