2GIG GoControl - How to Cycle the Power

1. Disarm the system with your master or user code, then unplug the transformer

GC_Transformer.png

2. Locate and remove the screw on top of the keypad, and pry open slots with a flat head screwdriver

GC2_Slots.jpg

3. Gently pull the front cover down

4. Locate the third hand (a plastic piece that looks like an upside-down V), and place it over the notch in the center of the cover

GC2_Circuit_Board.jpg

5. Locate the green battery pack, and remove the clip that connects the battery to the circuit board (black and red battery wire)

6. Remove the battery, then wait 2 minutes and reconnect it

7. Reassemble the keypad, and plug in the transformer

 

Was this article helpful?
0 out of 1 found this helpful

Comments

0 comments

Please sign in to leave a comment.