2GIG GoControl - Program A RF Sensor

 

1. Enter sensor to program or scroll sensors with Left or Right Arrows then press Down Arrow to select

2. Enter sensor type 01 to 24 or press Left or Right Arrow buttons to scroll Sensor Types then press Down Arrow to select, 00 disables sensor

3. If Sensor Type 04, 06, 07, 08, 10 and 23 was selected enter Equipment Type then press Down Arrow

4. Enter 0000 to 9999 or press Left or Right Arrow buttons to scroll Equipment Codes then press Down Arrow

5. If "Other" was selected in the previous step pick a number from 0000 to 9999 then press Down Arrow

6. Enter serial number from sensor sticker or press SHIFT then LEARN then activate sensor or sensor tamper to learn then press OK

7. Press Down Arrow to continue

8. Enter 0 or 1 or press Left or Right Arrow buttons to select Equipment Age then press Down Arrow

9. Enter Loop Number 1 to 3 then press Down Arrow

10. Enter 0 or 1 or press Left or Right Arrow keys to select if 30 second dialer delay is enabled then press Down Arrow

11. Press INSERT then enter 1st 3-digit word or press Left or Right Arrow buttons to scroll all words

12. Press INSERT then enter 2nd 3-digit word (up to 6 total) or press Left or Right Arrow buttons to scroll all words then press Down Arrow for next

13. Enter 0 or 1 or press Left or Right Arrow keys to select if sensor reports to Brinks Security then press Down Arrow

14. Enter 0 or 1 or press Left or Right Arrow keys to select if sensor is supervised then press Down Arrow

15. Enter 0 to 13 or press Left or Right Arrow keys to select sensor chime then press Down Arrow

16. Press EDIT NEXT for next keypad or SKIP to exit to go to Q2 Wired Sensor Programming

 

Was this article helpful?
0 out of 0 found this helpful

Comments

0 comments

Please sign in to leave a comment.