2GIG GoControl - Programming A Wired Sensor

1. Enter Sensor 01 or 02 or scroll with Left or Right Arrow buttons to select then press Down Arrow

2. Enter 00 to disable or 01 to 24 or press Left or Right Arrow buttons to scroll Sensor Type then press Down Arrow

3. If Sensor Type is 04 Interior, 23 No Response or any 24-Hour Alarm select Equipment Type then press Down Arrow

4. Pick a number from 0000 to 9999 then press Down Arrow

5. Enter 0 or 1 or press Left or Right Arrow buttons to select Equipment Age then press Down Arrow

8. Enter 0 to 3 or press Left or Right Arrow buttons to select type of hardwire wiring then press Down Arrow

9. Enter 0 or 1 or press Left or Right Arrow keys to select if 30 second dialer delay is enabled then press Down Arrow

10. Press INSERT then enter 1st 3-digit word or press Left or Right Arrow buttons to scroll all words

11. Press INSERT then enter 2nd 3-digit word (up to 6 total) or press Left or Right Arrow buttons to scroll all words then press Down Arrow for next

12. Enter 0 or 1 or press Left or Right Arrow keys to select if sensor reports to Brinks Security then press Down Arrow

13. Enter 0 to 13 or press Left or Right Arrow keys to select sensor chime then press Down Arrow

14. Press EDIT NEXT for next keypad or SKIP to exit to go to Q3 RF Keyfob Programming

Was this article helpful?
0 out of 0 found this helpful

Comments

0 comments

Please sign in to leave a comment.