GC3 - Add Z-Wave Thermostat

 2. Press SMART HOME SETTINGS then press ADD DEVICES

3. 2GIG GC3 enters learn mode, at the thermostat 

Alarm.com ADC-T2000

1. Press MODE button to display temperature, press MODE until heat/cool icons disappear

2. Hold DOWN ARROW until Radio Wave Icon appears below temperature display 

Alarm.com ADC-T3000

1. Press MENU button to display Menu then press DOWN ARROW until SETTINGS

2.  Press ENTER button to select then press DOWN ARROW until NETWORK 

3. Press ENTER button to select then press UP or DOWN ARROW to highlight ADD

4. Press ENTER button to select and start Z-Wave learn mode

5. Learning may take up to 1 minute to complete and exit

 Radio Thermostat CT20 or GE IS-ZW-TSTAT-100

Remove top cover then press the MATE button

Radio Thermostat CT30, CT100, CT100+ and CT101

1. Press MENU button, r1 displays

2. Press MATE under antenna icon twice then display LINK if successfully learned

Radio Thermostat CT110

   Press the left side Antenna button

 GoControl or RCS Technologies TBZ-48 

1. Hold FAN button 5 seconds until SETUP appears then UP ARROW button until ZWAVE

2. Press MODE button to select then press MODE button again to learn

3. If successful press FAN button to exit, antenna icon appears by temperature display

Trane Thermostat

1. Press MENU button then scroll down to Z-WAVE INSTALL and press SELECT button

2. Press Scroll UP button for YES to begin Z-Wave enrollment

3. If successful displays main menu, press DONE button to exit

5. If successful Adding Device displays press OK when finished

6. Press RENAME then enter a new name for the thermostat then press DONE

 7. Press  or the HOME button to exit