IQ Panel 2 - Add Thermostat

1. Press or swipe down clock display at top for Settings Tray then press SETTINGS

2. Press ADVANCED SETTINGS then enter Installer Code 1111

3. Press INSTALLATION then DEVICES

4. Press ADD DEVICE then PAIR

5. IQ Panel 2 enters Z-Wave learn mode

Alarm.com ADC-T2000 Thermostat

1. Press MODE button to display temperature, press MODE until heat/cool icons disappear

2. Hold DOWN ARROW until Radio Wave Icon appears below temperature display 

Alarm.com ADC-T3000 Thermostat

1. Press MENU button to display Menu then press DOWN ARROW until SETTINGS

2.  Press ENTER button to select then press DOWN ARROW until NETWORK 

3. Press ENTER button to select then press UP or DOWN ARROW to highlight ADD

4. Press ENTER button to select and start Z-Wave learn mode

5. Learning may take up to 1 minute to complete and exit

Radio Thermostat CT-20 and GE IS-ZW-TSTAT-100 Thermostat

Remove top cover then press MATE button

Radio Thermostat CT30, CT100, CT101

1. At thermostat press MENU button, "r1" displays and MATE appears under antenna icon

2. Press MATE, which begins flashing, if successful LINK appears, press MENU to exit

Radio Thermostat CT110

Press left side Antenna button

GoControl RCS Technologies TBZ-48 

1. Hold FAN button 5 seconds until SETUP then press UP ARROW button until ZWAVE

2. Press MODE button to select then press MODE button again to learn

3. If successful press FAN button to exit, antenna icon appears by temperature display

Trane Thermostat

1. Press MENU button twice, press Down Arrow to ZWave Install then press SELECT button

2. Press Up Arrow button then when finished press DONE to exit

Qolsys Programming continued...

6. Press NAME then select name or press CUSTOM NAME to create a name

7. If Custom Name press CUSTOM DESC, enter name then press CHECK or KEYPAD icon

8. Press ADD to save, press BACK or HOME to exit