IQ Panel 2 - LiftMaster Programming

Identifying the Components

The 888LM is the Control Panel mounted on a wall usually by inside garage door

 01_888LM_Control_Panel.jpg

828LM Gateway links MyQ Garage Door opener to Internet Router by WiFi

828LM_WiFi_Gateway_01.jpg

Compatibility

Any LiftMaster or Chamberlain garage door opener with integrated MyQ

There are two types of protocol compatible with the gateway...

A. Security + 

If no MyQ logo press purple learn button use the LiftMaster control panel

lm_indi.png

B. "Security + 2.0"

This control panel will have a MyQ logo and a Learn button

 

LM4.jpg

Connecting Control Panel to Garage Opener

1. Connect the red and white wires to the control panel                                                                              LM5.jpg

2. Wait until Control Panel finishes charging, Yellow LED will remain illuminated

The door can be tested by pressing the center push button

Note: Control panel's used with Security + 2.0 garage door openers do not have to charge

Setting Up 828LM Gateway Device through Alarm.com

1. Connect Ethernet cable to Gateway then power up and wait until Green LED turns ON

02_828LM_Internet_Gateway.jpg

2. Add Gateway into Alarm.com by selecting "Get Started!"

Picture1.png

 3. Enter the Gateway serial number and the account will attempt to connect with the device

Picture2.png

Learning Control Panel(s) to the Gateway Device

1. Enable Learn Mode on gateway. This causes the yellow LED on the gateway to turn on

  picture_3.jpg

 2) Press LEARN button on control panel, when connected to the Gateway blue LED turns ON

LM91.jpg02_828LM_Internet_Gateway_LEDs.jpg

 

Was this article helpful?
0 out of 0 found this helpful

Comments

0 comments

Please sign in to leave a comment.