Simon XT - Add Z-Wave Device

Follow the manufacturer's directions to install and power up the Z-Wave device and make sure that it is working properly locally before adding it to the Z-Wave network. We recommend an HVAC professional for thermostat installations.

1. Hold * button for 10 seconds

Simon_XT_Light_1.pngSimon_XT_Then.jpg  Simon_XT_Z-Wave_Add_01.png

2. Hold 1 for 10 seconds to enter Device add mode

 Simon_XT_Z-Wave_Add_02.pngSimon_XT_Then.jpg Simon_XT_Z-Wave_Add_03.png

3. Press MATE button on device (see list of devices below), if successful Simon XT beeps

Simon_XT_Z-Wave_Add_02.pngSimon_XT_Then.jpg Simon_XT_Z-Wave_Add_05.png

4. Hold # for 10 seconds to exit

Simon_XT_Z-Wave_Add_07.png Simon_XT_Then.jpg Simon_XT_Disarmed.png

 

GE Plug-in Lamp or Light/Appliance Module
Double click the button in the middle of the light or appliance module.

Picture2.png

GE In-Wall Dimmer or On/Off Light Switch
Turn on and off the light switch.

Picture4.png

GE In-Wall Outlet
Double click the button in the middle of the outlet.

Picture3.png

Schlage Lever Lock or Deadbolt
On the lock keypad, enter the six-digit programming code (provided in the documentation from Schlage), then press the Schlage button, followed by 0. The Schlage button will flash orange for a minute. Wait until the light flashes green before disrupting the lock or panel. Failure to do so will result in lock malfunctions.

Kwikset Deadbolt
Open the back cover and press the white button at the top left. Wait until the red light (under the paper next to the button) stops flashing before disrupting the lock or panel. Failure to do so will result in lock malfunctions.

Picture5.png

GE Basic Thermostat
Press the black Mate button located under the top cover on the upper right hand side.

9.JPG

GE Advanced Thermostat (IS-ZW-TSTAT-300)
Press the Menu button then press Mate twice on the screen, LINK should appear under the Antenna icon

1_300T.png2_300T.png

Trane Remote Energy Management Thermostat
Press the Menu button twice then scroll down to Z-Wave Install and press Select then press Yes.

1_Trane.png2_Trane.png     

IQ Siren
Press the button at the bottom of the siren.

Screenshot_at_Feb_08_15-20-59.png

IQ Thermostat
Press and hold the "Home" key for 2 seconds until you see the "NOC". Then press the "Program" key. It will display "Srh", meaning that the thermostat is searching for the network.

1.png2.png

Once the network is found, it will show "done". Then press the "Home" key to go back to the default screen.

3.png 4.png

 

More details on installation and troubleshooting can be found here.

A video for adding a Z-Wave device to the Simon XT can be found here.

Was this article helpful?
0 out of 0 found this helpful

Comments

0 comments

Please sign in to leave a comment.