IQ Panel 2 - LiftMaster Installation

Step 1: Install 888LM MyQ Control Panel

01_888LM_Control_Panel.jpg

  1. Disconnect all electrical power to garage door opener
  2. Remove existing door control from wall
  3. Note polarity of wires connected to existing door control and label wires (Red/White)
  4. Disconnect wires from existing door control
  5. Connect wires to new MyQ Control Panel
  6. Mount MyQ Control Panel to the wall then reconnect power
  7. Yellow and red LED blink for 5 minutes as MyQ Control Panel recharges
  8. Test MyQ Control Panel, press push bar to activate garage door opener
  9. Connect to LiftMaster Internet Gateway (See instructions below)

Step 2: Connect LiftMaster Internet Gateway

02_828LM_Internet_Gateway.jpg

  1. Connect Ethernet cable to router and 888LM Internet Gateway
  2. Connect power to 888LM Internet Gateway
  3. When 888LM Internet Gateway connects to internet, the green light turns solid
  4. Write down serial number on 888LM Internet Gateway to be used during registration

Step 3: Register Internet Gateway

Internet Gateway cannot be registered with Alarm.com if it is registered by LiftMaster
Delete Internet Gateway from MyQ account before attempting to register it

  1. Log into your account by using your customer credentials
  2. Access garage door registration through emPower -> Garage
  3. Enter the serial number of the Gateway and continue
  4. Select Add New Device to put the Gateway into learn mode
  5. Perform either of the two scenarios listed below:

Scenario #1: After the yellow light is on at the internet
gateway, go to the MyQ Control Panel (888LM) and push the
learn button twice. The LED on the gateway will turn blue
once the device is learned in.

Scenario #2: After the yellow light is on at the internet
gateway, enter menu > program > MyQ device on the
Control Panel (e.g. 880LM). The LED on the gateway will turn
blue once the device is learned in.

   6. Return to the Garage page and click “Check for New Devices”.
   7. Repeat steps 6-8 if initially unsuccessful

Was this article helpful?
0 out of 0 found this helpful

Comments

0 comments

Please sign in to leave a comment.