ADC-V520IR Indoor Camera WiFi Setup

Connect camera to the network router by one of two methods. 

Ethernet Cable

Plug Ethernet cable into camera and port on network router and wait 2 minutes

wifi_setup.JPG

WPS WiFI Protected Setup Mode

1. Plug in camera power and wait 2 minutes, the camera LED should turn red

power.JPG

2. Hold camera side button for 5 seconds until front LED flashes blue

blue.JPG

3. Press and release WPS button on router or enable WPS mode in router programming

router.JPG

4. Wait 2 minutes, if successful camera LED turns green (if red try again)

Add camera to account

1. Go to the customer website using a PC or laptop and press Video

wifi1.png

2. Press Settings

wifi2.png

3. Press Add Video Device

wifi3.png

4. If the camera is found press Name then enter camera name then press INSTALL

wifi4.png

5. Alarm.com sends configuration data to the camera, this may take several minutes

wifi5.png

6. When finished press Live View to view camera image

wifi6.png

7. To configure WiFi press SETTINGS

wifi7.png

8. Select camera from drop-down box

wifi8.png

9. Scroll down and press Wireless Network

wifi9.png

10. Press SCAN

wifi10.png

11. Select wireless network

Alarm.com_Setup_10.png

12. Enter WiFi encryption then press NEXT

Alarm.com_Setup_11.png

13. Unplug Ethernet cable then cycle power to the camera and wait 2 minutes to reboot

11_Add_V520_Camera_-_Wireless_Complete.png

Was this article helpful?
3 out of 4 found this helpful

Comments

0 comments

Please sign in to leave a comment.