Brinks Home Indoor Camera - WiFi Setup

Connection to the Network

Connect the camera to the network router by one of two methods. 

Ethernet Cable

  • Plug camera into the network router using an Ethernet cable then plug in camera power and wait 2 minutes

wifi_setup.JPG

WPS WiFI Protected Setup Mode

1. Plug in camera power and wait 2 minutes, the camera LED should turn red

power.JPG

2. Hold camera side button for 5 seconds, LED should flash blue

blue.JPG

3. Press and release WPS button on the router to enable WPS mode in the router programming

router.JPG

4. Wait 2 minutes, if successful camera LED turns green (if the camera fails to connect it will turn red)

Brinks Home Security Setup

1. From the customer website select Video

01_Home_Page.png

2. Select Settings

02_Video_Page.png

3. Select Add Video Device

03_Video_Settings.png

4. If the camera is found press Name then enter the camera name then press INSTALL

04_Add_V520_Camera_-_Camera_Found.png

5. Alarm.com sends configuration data to the camera, this may take several minutes

05_Add_V520_Camera_-_Configuring.png

6. When finished press Live View to view camera image

06_Add_V520_Camera_-_Installation_Complete.png

7. If connected by Ethernet cable and needing to configure WiFi press SETTINGS

07_Add_Camera_-_Live_View_Program_Wireless.png

8. Select camera from dropdown box

Select_Camera.png

9. Scroll down and select Wireless Network

08_Add_Camera_-_Select_Wireless_Settings.png

10. Press SCAN

09_Add_Camera_-_Choose_Method.png

11. Select wireless network

10_Add_Camera_-_Found_Networks.png

12. Enter WiFi encryption then press NEXT

10_Add_Camera_-_Enter_Encryption.png

13. Unplug Ethernet cable then cycle power to the camera and wait 2 minutes to reboot

11_Add_V520_Camera_-_Wireless_Complete.png

 

 

 

 

 

 

 

 

 

Was this article helpful?
2 out of 3 found this helpful

Comments

0 comments

Please sign in to leave a comment.