GC3 - Program WiFi Access Point

  • Provides 2.4 GHz WiFi network to cameras or other WiFi devices
  • Range is limited compared to WiFi using a conventional WiFi router
  • Not available if GC3 is connected to 5 GHz WiFi network

1. Press SYSTEM SETTINGS then enter Master Code then press NETWORK SETTINGS

GC3_WiFi_Test_01_Ready_to_Arm.jpg GC3_WiFi_Test_02_Enter_Code.jpg

2. Press NETWORK SETTINGS then press ACCESS POINT

Access_Point_Setup_01_User_Menu.png Access_Point_Setup_02_Network_Menu.png

3. To use default settings move slider to ENABLE then press GC3_Back_Arrow.png or HOME button to exit

Access_Point_Setup_03a_Disabled.png Access_Point_Setup_07_Exit.png

To change settings press Pencil icon to the right to change each setting

Access_Point_Setup_03_Enabled.png

To change Access Point name press pencil icon by SSID then enter name then press DONE

Access_Point_Setup_04a_SSID_Name.png Access_Point_Setup_04_SSID_Name.png

To change Password press pencil icon by Password then enter password then press DONE

Access_Point_Setup_05a_Encryption.png Access_Point_Setup_05_Encryption.png

To change IP Address press pencil icon by IP ADDRESS then enter new address then DONE

Access_Point_Setup_06a_IP_Address.png Access_Point_Setup_06_IP_Address.png

Press SAVE ACCESS POINT SETTINGS then press GC3_Back_Arrow.png or HOME button to exit

Access_Point_Setup_08_Save.png Access_Point_Setup_07_Exit.png

Was this article helpful?
0 out of 0 found this helpful

Comments

0 comments

Please sign in to leave a comment.