ADC-V620PT Indoor Pan Tilt Camera Guide

This camera is discontinued but can still be added and viewed on an account


  • 1280 x 800 pixel video resolution
  • 77° horizontal x 54° vertical field of view
  • 350° horizontal x 125° vertical pan tilt
  • WiFi 802.11 b/g/n
  • Ethernet connection
  • No night vision capability
  • Operating Temperature 32°F to 104°F

Factory Default

Warning! Erases everything, camera must be re-added to and WiFi configured

 Insert pin into side reset hole and hold button 15 seconds until LED flashes red and green


WiFi Setup by WPS Enrollment

1. Hold WPS button in back of camera base for 5 seconds until front LED flashes blue


2. Press and release WPS button on router or enable WPS in router programming


2. Wait 2 minutes for the camera LED to turn solid green


Hardwire Connection to Router

Plug Ethernet cable into back of camera and into port in back of WiFi network router


Add Camera using Customer Website

Note: Camera must be connected to customer's router by Ethernet cable or by WiFi

1. Login to customer website and press VIDEO




3. Scroll to bottom of page and press ADD VIDEO DEVICE


4. Camera should be detected, enter camera name then press INSTALL


5. downloads information to camera, this can take up to 5 minutes


6. When complete press LIVE VIEW to view


7. To configure wireless press SETTINGS


8. Scroll down to the bottom of the page then press WIRELESS NETWORK


9. Press SCAN to scan for networks


10. Select WiFi network from list


11. Enter WiFi encryption then press NEXT


12. Remove power to camera, unplug Ethernet cable then power up and wait 2 minutes


Add Camera using Smartphone App

Note: Camera must be connected to customer's router by WiFi or Ethernet Connection

1. Press top left 3 Bars for side menu then press VIDEO then press top right GEAR icon

ADC-V620PT_Setup_by_App_01.png ADC-V620PT_Setup_by_App_02.png ADC-V620PT_Setup_by_App_03.png

2. Press ADD VIDEO DEVICE press INSTALL  then enter new camera name then press NEXT

ADC-V620PT_Setup_by_App_04.png ADC-V620PT_Setup_by_App_05.png ADC-V620PT_Setup_by_App_06.png

3. When camera finishes configuring press X to exit

ADC-V620PT_Setup_by_App_07.png   ADC-V620PT_Setup_by_App_08.png ADC-V620PT_Setup_by_App_09.png


  • Power cycle the camera by unplugging and plugging in power adapter
  • Move closer to WiFi router
  • If issues persist, try resetting the camera to factory defaults

LED Reference Guide

  • All OFF = No power
  • Solid Green = Local network and Internet connection OK
  • Flashing Green = Local network connection OK, Internet connection bad
  • Solid Red = No local network or Internet connection
  • Flashing Red = Camera booting
  • Flashing Blue = Camera in WPS WiFi learn mode
  • Solid Blue = Privacy mode, press and release WPS button to exit
  • Flashing White = Camera in WiFi AP learn mode
  • Flashing Yellow = Camera in Bluetooth Pairing mode
Was this article helpful?
0 out of 0 found this helpful