ADC-SG130 Smart Gateway - Installation Guide

WiFi Access Point that can connect up to 4 cameras to customer's router

Specifications

  • 2.4 GHz, does not support 5 GHz devices
  • WiFi 8021.11 b/g/n/ac
  • Ethernet connection
  • Operating temperature 32° F to 104° F

ADC-SG130_Smart_Gateway.jpg

Factory Default

Insert paperclip into side hole then hold reset button  15 seconds until all lights flash

ADC-SG130_Smart_Gateway_Reset_Button.jpgADC-SG130_Smart_Gateway_Status_LEDs.jpg

Camera WiFi Setup by WPS Enrollment Mode

1. Press side WPS button 3 to 5 seconds, WiFi LED slowly flashes

ADC-SG130_Smart_Gateway_WPS_1.jpgADC-SG130_Smart_Gateway_WPS_2.jpg

2. Enable WPS mode in camera, usually by holding WPS button 5 seconds

ADC-V522IR_Camera_WPS_Enrollment.jpg

Hardwire Ethernet Connection to Customer's Router

Connect Ethernet cable to ADC-SG130 and unused port on network router

ADC-SG130_Smart_Gateway_Connection_To_Router.jpg

 Add Gateway to Account by Customer Website

 1. Login on laptop or home computer to Alarm.com customer website and press VIDEO

01_Home_Page.png

2. Press SETTINGS

02_Video_Page.png

3. Scroll to bottom of page and press ADD VIDEO DEVICE

 03_Video_Settings.png

 4. Enter MAC Address found on back of Smart Gateway then press FIND

Smart_Gateway_Installation_01_Enter_MAC_Address.jpg

5. Press NEXT to continue

SG100_Customer_02_Popup_1.png

6. Press OK during configuration

SG100_Customer_03_Popup_2.png

7. Alarm.com downloads information to Gateway, this may take 5 to 10 minutes

SG100_Customer_04_Updating.png

8. When finished press HOME to exit

SG100_Customer_05_Complete.png

Was this article helpful?
0 out of 0 found this helpful

Comments

0 comments

Please sign in to leave a comment.