ADC-V522IR Indoor Camera Guide

Specifications

• 1920 x 1080p video resolution
• 113° horizontal and vertical field of view
• 15' Night Vision range
• 802.11 b/g/n WiFi
• Ethernet connection
• Micro SD Card slot (not functional at this time)
• 2-way audio
• Operating Temperature 32° F to 104° F

Factory Default

Warning! Erases everything, camera must be re-added to Alarm.com and WiFi configured

Insert paper clip into reset hole and hold internal button for 15 seconds

WiFi Setup by WPS Mode

1. Insert paper clip into reset hole and hold internal button 5 seconds until LED flashes blue

2. Press and release router WPS button or enable WPS in router programming

3. Camera LED turns green after 1 minute if successful

WiFi Setup by Access Point Mode

1. Insert paper clip into reset hole and hold internal button 6 seconds until LED flashes white

 

2. Go to smartphone WiFi settings, select "ALARM xx:xx:xx" then press CONNECT

  

3. Open web browser and enter 192.168.1.1, camera menu appears, select language

  

4. Press SCAN FOR WI-FI NETWORKS, when found select WiFi network

  

5. Select SECURITY KEY then enter WiFi encryption key then press SAVE then OK to exit

  

6.  Camera green LED turns ON if successful

  

Hardwire Ethernet Connection to Router

Connect Ethernet cable from camera to port on back of router and power up camera

Add Camera to Account by Customer Website

Note: Camera must be connected to customer's router by WiFi or Ethernet Connection

1. Login to Alarm.com customer website and press VIDEO

2. Press SETTINGS

3. Scroll to bottom of page and press ADD VIDEO DEVICE

4. Camera should be detected, enter camera name then click on INSTALL to continue

5. Alarm.com downloads information to camera, this may take up to 5 minutes

6. When complete press LIVE VIEW to view camera

7. If connected by Ethernet and needing to configure WiFi press SETTINGS

8. Scroll down to the bottom of the page then press WIRELESS NETWORK

9. Press SCAN to scan for networks

10. Select WiFi network

11. Enter WiFi encryption then press NEXT

12. Power camera down then unplug Ethernet cable then power up and wait 2 minutes

Add Camera to Account by Smartphone App

Note: Camera must be connected to customer's router by WiFi or Ethernet Connection

1. Press top left Bars to access side menu then select VIDEO then press top right GEAR icon

  

2. Press ADD VIDEO DEVICE then press INSTALL then enter camera name then NEXT

  

3. Camera may take several minutes to configure, press X at top left to exit

  

Troubleshooting

• Solid Green = Local network and Internet connection OK
• Flashing Green = Local network connection OK, Internet connection bad
• Solid Red = No local network or Internet connection
• Flashing Red = Camera booting
• Flashing Blue = Camera in WPS WiFi learn mode
• Flashing White = Camera in WiFi AP learn mode
• Flashing Yellow = Camera in Bluetooth Pairing mode