ADC-V722W Outdoor Camera Guide

This camera is discontinued but can still be added and viewed on Alarm.com account

Specifications

• 1920 x 1080 pixel video resolution
• 88° horizontal and vertical field of view
• 40' night vision
• WiFi 802.11 b/g/n
• Operating temperature -4 °F to -122°F

Factory Default

Warning! Erases everything, camera must be re-added to Alarm.com and WiFi configured

 Hold back button for 15 seconds until LED flashes red and green

WiFi Setup by WPS Enrollment Mode

1. Hold back button for 5 seconds, LED flashes blue

2. Press and release WPS button on router or enable WPS mode in router programming

3. After 2 minutes camera LED turns green if successful or red if failure

WiFi Setup by Access Point Mode

1. Hold back button for 6 seconds until LED flashes white

2. Go to smartphone WiFi settings, select ALARM (xx:xx:xx) then press CONNECT

3. Open web browser and enter 192.168.1.1, camera menu appears, select language

4. Press SCAN FOR WI-FI NETWORKS, when found select WiFi network

5. Press SECURITY KEY then enter WiFi encryption key then press SAVE then OK to exit

6. Camera LED turns green if successful or red if failure

Add Camera to Account by Customer Website

 Note: Camera must be connected by WiFi to customer's router

1. Login on a laptop or home computer to Alarm.com customer website and press VIDEO

2. Press SETTINGS

3. Scroll to bottom of page and press ADD VIDEO DEVICE

4. Camera should be detected, enter camera name then press INSTALL

5. Alarm.com downloads information to camera, this may take up to 5 minutes

6. When complete press LIVE VIEW to view video

Add Camera to Account with Smartphone App

 Note: Camera must be connected to customer's router by WiFi

1. Press top left Bars to access menu then press VIDEO then press upper right GEAR icon

2. Press ADD VIDEO DEVICE then press INSTALL then enter camera name then press NEXT

3. Camera may take several minutes to configure, press X at top left to exit

Troubleshooting

LED Reference Guide

• Off - No power
• Green ON - Internet and Alarm.com connection OK
• Red On - No local or Internet connection
• Red Blink - Factory reset or firmware upgrade
• Red ON - No access to Internet or Alarm.com