GC3 GoControl - Programming A Door / Window Sensor

1. Press SYSTEM SETTINGS then enter Installer Code 1561 then press INSTALLER TOOLBOX

1_GC3_GoControl.png2_GC3_GoControl.png3_GC3_GoControl.png

2. Press SYSTEM CONFIGURATION then press WIRELESS ZONES then select Wireless Zone 001 to 100 on the left then press EDIT ZONE

4_GC3_GoControl.png5_GC3_GoControl.png6_GC3_GoControl.png

3. Press SENSOR TYPE then press to choose from the list of all Sensor Types

8_go.png7_go.png9_go.png

4. If Sensor Type 04, 06, 07, 08, 10, or 23 was selected enter Sensor Equipment Type

10_go.jpg

5. Press EQUIPMENT CODE then press to choose from list of all Equipment Codes

11_go.png12_go.png

6. Press SERIAL NUMBER then enter serial number or press LEARN button then activate sensor then press ACCEPT to finish

66_go.png13_go.png14_go.png

7. If enabled press SMART AREAS then select which partition 1 to 4 sensor has access

15_go.png

8. Press EQUIPMENT AGE then select if New or Used (for reference only and doesn't affect anything)

16_go.png

9. Press SENSOR LOOP then select loop number

17_go.png18_go.png

10. Press TRANSMISSION DELAY and set to enable or disable (time is set in Q39)

19_go.png

11. Press VOICE DESCRIPTOR then EDIT VOICE DESCRIPTOR, enter 1st letter of word then select word (up to 6) from list then press DONE to finish

20_go.png21_go.png

12. Press SENSOR REPORTS then select enable or disable

22_go.png

13. Press SENSOR SUPERVISED then select enable or disable (Leave on for all but Panics)

go_23.png

14. Press SENSOR CHIME then select from the list then press NEXT ZONE for next sensor or RETURN TO          SYSTEM CONFIGURATION to exit

go_24.pnggo_25.png

Was this article helpful?
0 out of 0 found this helpful

Comments

0 comments

Please sign in to leave a comment.