Honeywell Tuxedo Touch - Remove Z-Wave Device

The below steps will walk you through removing an existing Z-Wave device from the Honeywell Tuxedo Touch panel. Please note that some Z-Wave devices require 24 hours to update before they can be added after being removed.

 

1. From the Automation menu press the Z-Wave toolkit icon, then press ADD DEVICE

f001_image.jpg f002_image.jpg


2. Press the Learn or Mate button on the light module or garage door controller, or enter thermostat or door lock programming to remove

f003_image.jpg f004_image.jpg

Was this article helpful?
0 out of 0 found this helpful