ADC-V724 Outdoor Camera Guide


  • 1920 x 1080 pixel video resolution
  • 117° field of view
  • 45' infrared vision range
  • microSD Card slot
  • Wi-Fi with Two-Way Audio
  • 12 V – 1 A DC power adapter (included)
  • Operating temperature -4°F – 122° F ( -20°C – 50°C)





  • Two-Way Audio to hear and speak with visitors
  • Perimeter Guard
  • Microphone and speaker
  • Video Analytics for smarter detection and relevant alerts
  • Onboard Recording with Smart View for continuous, local, encrypted recordings
  • High Dynamic Range (HDR)
  • Wi-Fi (2.4 or 5 GHz)
  • Audio included in recorded clips for additional awareness
  • Works with the Brinks Home Mobile App
  • Improved mount for long-term stability
  • Easier access to microSD card door


Factory Default

Hold the reset button while powering up and continue holding for 10 seconds


Pre-Installation Steps

This brief video reviews pre-installation steps for the Brinks Home Outdoor Camera (ADC-V724):


Add Camera using Brinks Home App Website

This brief instructional video demonstrates how to successfully add the Brinks Home Outdoor Camera (ADC-V724) to the Brinks Home App website:


Step-by-Step Instructions:

1. Login to the Brinks Home App website (powered by and select VIDEO



2. Select SETTINGS






4. Camera should be detected, enter name, then select INSTALL



5. The camera is added to the network, which can take several minutes



6. When finished select LIVE VIEW to view images from newly installed camera



Add Camera using Brinks Home Mobile App

1. From the menu icon in the top left, press VIDEO, then the GEAR icon

ADC-VC736_Setup_by_App_01.png ADC-VC736_Setup_by_App_02.png ADC-VC736_Setup_by_App_03.png


2. Press ADD VIDEO DEVICE, then INSTALL, enter the camera name, then press NEXT

ADC-VC736_Setup_by_App_04.png ADC-VC736_Setup_by_App_05.png ADC-VC736_Setup_by_App_06.png


3. Camera may take several minutes to configure. Press X when finished.

ADC-VC736_Setup_by_App_07.png ADC-VC736_Setup_by_App_09.png ADC-VC736_Setup_by_App_08.png



  • Power cycle the camera by unplugging and plugging in the power adapter
  • Move the camera closer to the Wi-Fi router
  • If issues persist, try resetting the camera to factory defaults and reinstalling


LED Reference Guide

  • Off - no power
  • Green on - internet and connection ok
  • Red on - no local or internet connection
  • Red blink - factory reset or firmware upgrade
  • Red on - no access to the internet or
Was this article helpful?
0 out of 0 found this helpful