Find the image of your carbon monoxide detector below to view instructions on how to replace the cover on your sensor to address the tamper error.

You will also need to clear the error from the panel memory. Once the cover has been replaced, see instructions for GC2 GoControl - Silence Reset Trouble.

 

2GIG-CO3-345 Carbon Monoxide Detector:

Align the sensor over the base, pressing it into place, then twist clockwise to replace the sensor.

3.1_2GIG_CO3-345.png

______________________________________________________________________________

Honeywell 5800CO Carbon Monoxide Detector:

Align the sensor over the base, pressing it into place, then twist clockwise to replace the sensor.

3.2_Honeywell_5800CO_Carbon_Monoxide_Detector.png

Was this article helpful?
0 out of 0 found this helpful