Find the image of your smoke detector below to view instructions on how to replace the cover on your sensor to address the tamper error.

You will also need to clear the error from the panel memory. Once the cover has been replaced, see instructions for GC2 GoControl - Silence Reset Trouble.

 

2GIG 2GIG-SMKT3-345 Smoke Detector:

Align the sensor over the base, holding it against the base, and twist clockwise to set it in place.

3.1B_2GIG-SMKT3-345.jpg.png

Line.jpg

Honeywell 5808W3 Smoke Detector:

Align the sensor over the base, holding it against the base, and twist clockwise to set it in place.

3.2B_5808W3.png

Line.jpg

Honeywell 5800 Combo Smoke Detector:

Align the sensor over the base, holding it against the base, and twist clockwise to set it in place.

3.3B_5800.png

Line.jpg

Honeywell 5808W3A Smoke Detector:

Align the sensor over the base, holding it against the base, and twist clockwise to set it in place.

3.4B_5808W3A.png

Line.jpg

2001RFH Smoke Detector:

Align the sensor over the base, holding it against the base, and twist clockwise to set it in place.

2.2-3.5B_2001_RFH.png

Was this article helpful?
0 out of 0 found this helpful